Search results
Search results 1-20 of 87.
Testing v1.21 vs v1.20.11 Can be replicated by adding a couple of hotspots to the followmouse example files. While the pano follows the mouse the hotspot animiation is smooth on v1.20.11 but judders on v1.21. Is this just me ? Thanks
Thanks for the clarification!
Will take a look thanks...
Is there currently anyway to make the v1.21 feature "use3Dtransition" blend vertically either up or down. e.g. in the case of moving between floors? Thanks GeoK
Have that also. Seems to occur after deleting geometry and / or pano from project. After that I cannot recover the project by saving/closing/opening again. Have to start again. Only started recently happening. I work around by saving after almost every change, doing a save-as new file that way I can recover it again if needed.
Forget that, I had to remove alignment.....sorted.
Dragging another pano into EP3D the horizontal is off by 45 degrees or so? Any suggestions why....? The other 40 panos are fine ! Thanks George
Re-created and is OK.......
Issue just started, clicking edit model shows blank workspace. Clicking anywhere in the workspace shows grid and models defined so far. Only one defined model shows in the model list. 1st pic shows screen when edit model clicked, 2nd after clicking on workspace, 3rd in 3D mode but only 1 of 3 models showing in list.
Thanks for sharing, will take a look.
Nice workaround for the problem, sticking to wanting the industry standard (right click) implemented though
I know and appreciate the current product blocks this. This is a feature request for a future version and only when a dollhouse is in view....
Can I request that when a 3Dmodel/Dollshouse is in view that the right mouse click is used to move it around in 3D space. When not in view the current context menu would be displayed as normal. Eg. as it does in Sketchfab (and others) for example, https://skfb.ly/oAOzN Makes it much easier to manipulate the model! Thanks
Wondering about how to go about adding the scene title as a room label on the 3D model? Placed dead centre in each scene... Ideally visible in "floorplan" view i.e. directly overhead looking straight down at the centre of the model (useful to have this as a standard feature - like Matterport does) Example image attached Suggestions welcome !
Had that before - checked the folder and all the files had been generated so killed the Everpano process to force it to quit. No idea why.
Loaded up to Sketchfab https://sketchfab.com/3d-models/1cbd52a8…687e5b2e552f0e4 Needs a tidy up as there are overlapping surfaces causing some flicker here and there. Comments welcome for suggestions for improvement. Thanks.
Hi jordi, Could you check this is the case? Bit of problem without it for me..... Thanks
Thursday, March 30th 2023, 12:47pm
Go to the top of the page
