For doing that in an automatic way, first you should have every pano with an orientation value set in the scene or in any other array, also you could have them previously oriented in the same direction (in photoshop ) so that value could be 0 all the time, and so you don't even have to set up this.

Then of course you will need some code that proces that values.
Basically you need to compare the view.hlookat from current pano and the values of orientation of both panos. And then you can get the view.hlookat of next pano.

If you have them oriented previously, then just make a keepview flag for the loadpano.

Hope it helps

i think there will be 2 ways！

1 you can use PTgui set the center of pano to same orientation （change X），for example ，to east，that all your pano hlookat="0" means to the east direction,and you can just use KEEPVIEW http://www.krpano.com/docu/actions/#loadscene



2

before enter a new scene，get b，
then in the new scene sub(view.hlookat,b,layer[radar].heading); and you get view.hlookat

maybe you can use push/pop

Zitat

before enter a new scene，get b，then in the new scene sub(view.hlookat,b,layer[radar].heading); and you get view.hlookat

I think that with this method, pano would be loaded in the default point of view and then just jump to the correct one. So every calculation should be done before loading pano

my poor english,yes,that is what i mean

I found sth useful for your need
http://www.krpano.com/docu/actions/#loadpano
vars* can send sth to new pano but before starting the pano viewing.